주요 콘텐츠로 건너뛰기

Apple iPhone 5s는 2013년 9월 10일에 발표되었습니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 은색, 금색 및 스페이스 그레이.

3530 질문 전체 보기

Error 4013/ Red screen with blue screen

Hello guys,

I have a problem with my iphone 5s. The phone stays in a reboot loop. After i connected it with the iphone and try a recovery, it gives me error 4013. I tried 2 screens, changed the back camera, and tried the recovery without the screen plugged on the iphone.I also tried three different batteries. The original one, and two fake ones. I keep getting flashes of a blue and a red screen in the recovery process. I also tried two different systems with itunes and keep getting the same error, also changed the lightning cable.

I am out of options. Can someone help me?

Update (09/29/2016)

Could it be something else? Because I also read something about the u2/ic chip reheating.

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 2
댓글 2개

if you are thinking of heating the u2/ic chip ...make sure u apply a little heating , becos last time i tried to heat it the phone ended up dead...

The error is a hardware problem no solution for the error i am also try but not successed...

댓글 달기

답변 2개

가장 유용한 답변

It sounds like a case of long screw damage.

https://www.youtube.com/watch?v=TzlsG1M1...

That video shows how to repair and diagnose it.

해당 답변은 도움이 되었습니까?

점수 3

댓글 2개:

i see in the video that she uses a lot of advanced equipment. Can this be done with simple hometools?

Short answer: NO

댓글 달기

try and restore without screws on the fones some times it works and make sure u use a good cable

해당 답변은 도움이 되었습니까?

점수 0

댓글 2개:

Must I remove the logic board screws?

yes all of them

댓글 달기

귀하의 답변을 추가하세요

Rachid El Bali 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 10,912