6MB 공유 L3 캐시 2.2 GHz (Turbo Boost 최대 3.4 GHz), 2.5 GHz (Turbo Boost 최대 3.7GHz) 쿼드-코어 Intel Core i7 프로세서.

282 질문 전체 보기

Upgraded to 512GB SSD, now SSD link width down to x2 from x4?

I replaced the stock 256 GB SSD with 512 GB from same generation MacBook (2015 retina) and now my SSD controller link speed and width have decreased, disk benchmark has slowed.

Is there some configuration change I need to make in order to get x4 link width and back to better speeds?

256 GB/stock SSD:

Block Image

Block Image

Block Image

512 GB/replacement SSD:

Block Image

Block Image

Block Image

답변되었습니다! View the answer 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 2
의견 추가하세요

US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

상점 둘러보기

2개의 답변

선택된 해법

It's the part you put in is only a PCIe x2 unit not a PCIe x4 which is why the lane width dropped.

The newest version of the SSD is hard to come by and it will be more expensive. So far Apple doesn't offer it as a spare only as a swap out (you need to send the old one back) and it needs to be the same. Hopefully this control will end soon as the newer models don't use the same blade type of SSD. In any case it will be costly!

Update (02/08/2017)

Adam you'll need to get into the system profiler service to check the new SSD's firmware comparing it with your older SSD.

Open About This Mac and click on the System Report button. Click on NVMExpress and SATA/SATA Express sections, enlarge the window so all of the info on the right is visible snap a screenshot of each and post it here so we can see what each has.

As a reference review this question and what Eduardo encountered: Upgraded my SSD, Was it not suppose to keep same read/write rates?

해당 답변은 도움이 되었습니까?

점수 3

댓글:

The replacement SSD is from a 2015 Macbook Pro Retina and it was paid good money for (since I know they are rare). Are these not 4 lane?

Original 256gb SSD model: MZ-JPV2560/0A4

Replacement 512gb SSD model: MZ-JPV5120/0A5

의 답변

I wonder why Apple doesn't use regular M.2 SSDs. Do they really make enough prophet from replacements to justify a proprietary connection?

의 답변

Apple doesn't use regular M.2 SSDs because that standard was not finalized when they began using PCIe based SSDs in their machine. Once they had their own supply chain up it did not make sense to migrate to M.2

의 답변

But many of their pci-e SSDs are different. M.2 can be SATA based (b&m key) or PCI-E based (b-key). If their SSDs change with nearly every generation, why not just use the M.2 standardized connector?

의 답변

@pccheese - George, Apples SSD's are just different! You can't use a M.2 SSD in place of theirs.

Don't get off the subject here the focus in on why Adam's replacement Apple SSD fails to run at the same rate as the original.

The answer is: the lane width of the SSD was altered from the older models which had 2 lanes to the newer models having 4 lanes. So in a nutshell he bought a 2 lane SSD which was likely sold to him as a 4 lane.

The only other factor here is the SSD's firmware may not be for his system as it was taken from a MacBook Air which had an older cut of firmware.

의 답변

4에 댓글 더 나타내기

의견 추가하세요

were u able to figure out the cause? same here lane dropped after upgrading late 2013 MBP from 256GB (A/00) to 512gB (A/06)

해당 답변은 도움이 되었습니까?

점수 0

댓글:

The issue was the replacement SSD was only a two lane part vs the original SSD which was a four lane part.

의 답변

의견 추가하세요

귀하의 답변을 추가하십시오

adam.foley 가/이 대단히 고마워 할 것입니다.
조회 통계:

지난 24시간: 3

지난 7일: 31

지난 30일: 138

전체 시간: 3,003