기기를 수리하세요 커뮤니티 상점

2011년 7월 21일에 출시되었습니다. Core i5 또는 Core i7 프로세서. Thunderbolt. 이 기기는 Mac mini Server 구성을 실행하는데도 사용됩니다.

204 질문 전체 보기

옵션

Power Button Wiring Mac Mini 2011

Got a Mac Mini in for the fan connector replacement which has been replaced, however the wires going into the power button from the logic board have been pulled off by the customer when fitting the dual hard drive enclosure.

I'd like to strip and resolder the wires to the power button PCB, but could anyone confirm which wire goes where (black and a grey one), since I haven't got another one to hand, and it's possible they are in the wrong position.

Thanks.

Block Image

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 1
댓글 달기

답변 1개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

I don't think it matters, which goes on what side.

Double check using a Ohm meter to see if one side of the button contacts is chassis ground, if neither are it makes no difference.

해당 답변은 도움이 되었습니까?

예 아니요
점수 2

댓글 3개:

Thanks, I'll check once I'm in again on Saturday. I'm sure it said something like 'PWR1' and 'PWR2', but I only saw this when I peeled back the tape to see the wires were damaged, so I'm probably wrong

의

Its a soft switch - Momentarily contact blister switch, which is sensed within the power supply to kick the power supply on. Just like the iMac's

의

Thanks. Grey wire (gnd) goes on the left side and the black wire on the right side. Works fine now :)

의

댓글 달기

귀하의 답변을 추가하세요

Reece 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 7

전체 시간: 983