기기를 수리하세요 커뮤니티 상점

iPhone 액세서리 수리 및 분해 안내서입니다.

34 질문 전체 보기

옵션

Removing a hardened glass screen protector?

Hi,

Two friends have hardened glass screen protectors (stick-on) on their phones that have cracked. The phone's screen glass appears fine, it's just the protectors that have cracked, and need to get removed.

Attempting with a fingernail to get underneath a corner of the protector shows that they are very firmly stuck on...

I was thinking about a heat gun - very gently - to soften the adhesive. But I haven't tried it yet, nor anything else.

Anybody have any luck with these ?

If I have to experiment, the good news is that one of the phones in question is about to be replaced anyhow, so it might be a good guinea pig.

Cheers

Neil

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 3
댓글 달기

답변 3개

필터:
가장 유용함 가장 최근 가장 오래된
가장 유용한 답변

옵션

Use a razor blade to get underneath the screen protector. Once you get it under you can remove with your hands. But I recommend holding the screen down because it sounds like fairly strong adhesive used for the screen protector.

해당 답변은 도움이 되었습니까?

예 아니요
점수 3

댓글 1개:

Using a razor blade risks scratching the permanent screen underneath. Bad idea IMHO, unless as a LAST RESORT.

Not to mention the risk of injury if slipping with the razor blade. Perhaps an Xacto knife instead?

의

댓글 달기

옵션

https://youtu.be/jXmggAgojIY….follow my link to get your answer

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

옵션

I generally lift screen protectors with a looped piece of tape to the surface to break the adhesion and lift up so that I can remove a speck of dust from the underside. Using a fingernail or other soft plastic tool to dig underneath a protector risks bending/distorting the protector (bad if you are trying to reuse the protector, and just remove a dust mote). But a soft device/tool is preferrable to a razor blade or other metal that can gouge or scratching the device screen underneath.

If the adhesion is strong, you can move up from weak to stronger types of tape: 3M Scotch tape, packing tape, thin loop of duct tape....

If the protector has become "welded" to the screen, I would use a hair dryer (NOT a heat gun) to warm it up. You might also try the iFixit remover tool that you heat up in a microwave then lay over the screen to warm/soften adhesive.

Some screen protectors are (or were) applied with the help of water. I would NOT apply water directly to the device to try to loosen a protector. Perhaps just use a damp cloth? Try laying a damp cloth over the device, then the iFixit removal tool warmed up, then try in 10-15 minutes. Good luck!

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

귀하의 답변을 추가하세요

Neil 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 12

7일 전: 89

30일 전: 308

전체 시간: 22,960