주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

Samsung의 주력 휴대폰 Galaxy S8. 2017년 4월 출시.

204 질문 전체 보기

Why dissassemble entire phone to replace broken glass?

I need to replace the broken glass on a Galaxy S8. The LCD and digitizer are still fine, so I really only need to replace the glass, not the whole screen. Since entire screens are still $200 but the glass is just $20-30, obviously I want to replace just the glass. Although I haven't found a specific guide for that here on ifixit for just the glass replacement, there are plenty of YouTube videos of the process. One thing I don't understand is why they take apart the whole phone first from the back when only replacing the front glass. Can anyone tell my why that's important?

It seems to me I should be able to just apply heat directly to the front glass and take it off, then just glue a new glass on. I'd really prefer to not worry about messing up some of the internals.

답변되었습니다! View the answer 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 5
의견 추가하세요

LCD iPhone 스크린 수리 키트

평생 품질 보증이 적용되는 저렴한 옵션.

키트 쇼핑하기

LCD iPhone 스크린 수리 키트

수리의 질 말고 비용을 절감하세요.

키트 쇼핑하기

답변 4개

선택된 해법

LCD connector runs through the center plate and will rip if you try to take the front off first.

해당 답변은 도움이 되었습니까?

점수 5
의견 추가하세요

Hello,

you take apart the whole phone because the heat that is applied to the screen can damage the internals.

Edit: I know you need to apply heat to the back but it's safer.

해당 답변은 도움이 되었습니까?

점수 2
의견 추가하세요

It's just to protect the smaller components from the heat.

To be frank, I just removed the motherboard and carefully apply heat as I disassemble the LCD/Digitizer.

Once I get an opening I just apply small amount of heat and go through the adhesive in the back. I've never had an issue with this process.

The only time I completely disassemble the phone is when I need to preserve the LCD, this is for S7 and lower that requires you to get some access to the LCD to remove the motherboard.

good luck

해당 답변은 도움이 되었습니까?

점수 2

댓글:

If we use freezing technic to remove the glass, do we still need to diassemble the phone?

I'm not sure of this technique you speak of, nor have I heard of it.

Just remember the battery is exposed right behind the LCD/Digitizer. If you puncture it then you're going to want to get another one.

의견 추가하세요

You are right bro. I think no need to dismantling a whole phone especially only broken front glass . Heat up upper side slightly and pass wire between lcd and glass and seprate by intermittent heating and pulling wire , overtop at earpiece mesh. Care should be taken to LOCA applying is must .mask with tape entire rim of phone precisely before pouring of LOCA. Then clean exess and put under UV for curring. That's It.

해당 답변은 도움이 되었습니까?

점수 1
의견 추가하세요

귀하의 답변을 추가하십시오

Nicu Stiurca 가/이 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 6

7일 전: 42

30일 전: 248

전체 시간: 14,166