기기를 수리하세요 커뮤니티 상점

2.2, 2.4, 2.5, 또는 2.6 GHz Core 2 Duo 프로세서

759 질문 전체 보기

옵션

Suggestions for funky repair to cracked edge of display early 2008

USPS dropped the used MBP I recently bought. Bonked the corner near the power cable hookup (goes in askew, but functions), but worse, cracked the plastic edge of the screen (display OK). Opening the laptop makes the crack open further, and I can see the other side beginning to crack from the strain. Damage also makes the latch a bit of a struggle.

I’m thinking superglue the crack and perhaps gluing a rigid piece of metal to the closed side to reinforce. Replacing the display would cost 3X what I paid for the laptop, so no way.

Anyone have an opinion?

Block Image

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0
댓글 달기

답변 2개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 해법

옵션

So here’s my own answer to “funky fix”

I took a teensy wrench I had and cut it down on the end so it would obscure as little of the screen as possible. I then used 2-part mix epoxy between the piece and the screen frame, and clamped it on with a padded clamp for about 3 days (even though this was “5 minute epoxy"). Once I took the clamp off, I used a single edge razor to trim the metal piece slightly so the screen could shut a bit less tightly. It still gives a bit of pressure, which is good, since the release button now works without requiring an assistant. Since I only spent $63 for this MBP, this repair was WAY cheaper than any alternative, and relatively simple mechanically.

Block Image

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기
가장 유용한 답변

옵션

Sadly, the display frame in this series is weak, glueing won’t help. Take a look at this YouTube vid The horrible truth about Apple's repeated engineering failures

Time for a new lid assembly or a new system.

Update (10/19/2018)

Well, if you’re up to the challenge!

Do you have access to a 3D printer? Taking your old one apart and using the needed CAD program for your printer map it out and test your creation! Once you’ve got it all worked out take your CAD drawing to a C&C miller and mill it out of good quality aluminum.

You could even give it some embellishments too!

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 2개:

A new display assembly goes from 150$ to 400$ depending on the model number of your C2D MBP. You may be better off simply getting a new C2D MBP if you can find one in that price range I listed above for a new display assembly.

의

I do not want to replace the display with an expensive, equally fragile one. I would love a creative alternative repair suggestion.

의

댓글 달기

귀하의 답변을 추가하세요

Nono Ono 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 1

7일 전: 4

30일 전: 9

전체 시간: 68