주요 콘텐츠로 건너뛰기

2014년 9월 19일에 출시된 이 5.5” 스크린 iPhone은 iPhone 6의 큰 버전입니다.

1525 질문 전체 보기

iPhone 6 Plus Error 4013 after Screen, Logic, and Lightning replaced

I recently gained possession of an iPhone 6 Plus that I replaced the screen on for a friend. The phone then proceeded to boot loop until it ran out of power. Thinking that the device was fubar, he gave it to me. So I decided to try basically everything. Got to the point that I decided to replace the logic board after having heard that error 4013 can be NAND related. Did that. Still get the exact same error whenever I try to restore it with iTunes.

64GB AT&T Locked iPhone 6 Plus

Parts replaced:

  • Screen
  • Lightning and audio assembly
  • Logic Board
  • 5GHz wireless antenna

Any insight?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 2개

가장 유용한 답변

disconnect everything except chargeport and see if it will flash without errors, then if it goes through ok start connecting each component one at a time until you find the culprit.

해당 답변은 도움이 되었습니까?

점수 1

댓글 3개:

well... seems like the screen was the problem, but that raises a new question... how come a screen that was purchased from iFixit didn't let the phone boot or restore...

So, that "fixed" it, but now it just boot loops forever again... And I can't test the original screen anymore because it was practically unusable when I replaced it.

Bad front camera or home button flex from a screen that has preassembled components can cause this.

댓글 달기

That is Nand issues,Most of the cases you have to reprogram Nand with removing from logic board and reprogram with programmer.

해당 답변은 도움이 되었습니까?

점수 0

댓글 1개:

The logic board has already been replaced with a known good board. So the issue is no longer NAND related. Also, I was able to get it restored by taking the replaced screen off. So the issue is now with the screen and that it causes a boot loop whenever it’s connected.

댓글 달기

귀하의 답변을 추가하세요

John Peters 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 73