주요 콘텐츠로 건너뛰기

처리 속도가 빨라진 iPhone 3G 개선 버전. 이 기기의 수리는 3G와 유사하며 간단한 스크루드라이버, 비집는 도구가 필요합니다. 모델 A1303 / 16GB 또는 32GB 용량 / 검정 또는 흰색 플라스틱 뒷면.

1502 질문 전체 보기

power button - problem with button after fixing

Hi,

I have 3GS, in order to use the power button, u need to press really hard, in some point, and then it works (With pinching as well).

Volume buttons, headset, silent switch are working.

I opened the device, cleaned the button and the flex, made sure the button is in 180 to the back panel - but it didn't work.

what could resolve this?

thanks

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 -1
댓글 달기

답변 1개

가장 유용한 답변

Simple fix. This issue is not the button itself, it will be the flex beneath it that is the issue.Try to find some rubber of some sort that wont degrade. When i have come across this issue i use the rubber from HTC home buttons. Cut a very small piece out (approximately the size of the home button flex (pictured below)

Block Image

Use some fast drying glue/super glue and glue it inside the small circle. Make sure you are carful as you only have one shot at this as super glue dries very quickly. But don't worry too much if you break it as it is already possibly broken. Put the rubber in place and wait minimum 5 minutes for it to dry. Replace ribbon and home button and hope for the best! If it still does not work you can either buy a new Headphone jack assembly and install (make sure you know what you are doing before carrying out this type of part replacement as it is rather difficult) or you can buy a new back assembly and it will be pre-installed for you.

Headphone jack assembly -

iPhone 3G/3GS Headphone Jack Assembly

Back assembly -

http://www.macfixit.com.au/shop/index.ph...

iPhone 3G/3GS Headphone Jack Assembly 이미지

상품

iPhone 3G/3GS Headphone Jack Assembly

$14.99

해당 답변은 도움이 되었습니까?

점수 1

댓글 2개:

Hey martin,

Well.. The HTC tip is not possible cause I don't have it, plus I am not sure I understood.

But I would like to ask something else about the Headphone Jack Assembly:

Replacing this part to a new one, should I be carefull with something?

I understood that the Vibrate area has the mute button and some other parts that must be there and you must work very carefully there.

Thanks

Yes, below is a link to another post that has had a similar issue and i explain the issues with the ribbon in further detail. If i were you i'd just buy a new back assembly and be done with it. A lot easier and a lot less time consuming! Trick to getting the mute switch to stay in mute button?

댓글 달기

귀하의 답변을 추가하세요

Shai 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 8

30일 전: 15

전체 시간: 1,651