평판: 121
3
3
So I have to run a jumper from u4500-B3 to L4522, but L4522 it fully covered by the metal bracket. Should I just cut the bracket off in that area, or can you take the bracket off, and put it back on later? Thanks!
좋은 질문 입니까?
평판: 102.6k
10
54
291
In my opinion it’s much better to just cut off the needed part, if you have a decent tool for the job you are sure to avoid damaging the board. Removing the metal frame it’s not that hard but you can almost forget to be able to solder it back without making a mess..just my 2 cents ;)
해당 답변은 도움이 되었습니까?
Also be careful as there is a glass-bodied MOSFET just underneath the shield and it is very easy to damage when tearing off the shield.
@refectio Think it would be best to get a little dremel tool, and try and be very delicate?
24 시간 전: 0
7일 전: 0
30일 전: 0
전체 시간: 74
