기기를 수리하세요 커뮤니티 상점

Device repair and information for the Soundsticks II speaker, designed by Harman Kardon in 2004.

22 질문 전체 보기

옵션

I need a wiring diagram or service manual for the soundsticks II

I have a Harman/Kardon SoundSticks II subwoofer without any satellites (L & R), so I don’t have a volume control for it. I’ve had some luck with jumping two pins on the right speaker connector and connecting two speakers to the left speaker RCA jack. I would need some sort of wiring diagram or service manual If I want to figure out how to wire up the right channel (I want to use the system in stereo) without the volume control.

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 2
댓글 달기

답변 2개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

I found this useful pinout on Nick Brook’s site:

https://nickbrook.me/blog/2014-08-11/rep...

The R speakers are driven between pins 1 and 2 of the s-video 4 pin connector (the two furthest-apart ones, at the bottom, white and translucent in the cable). Pins 3 and 4 connect to the touch-sensitive pads on the R speaker for volume down (3) and volume up (4); you should be able to control the speaker volume by simply touching a bare wire connected to these pins with your finger (I think it detects mains hum or something). Note: Touching both volume controls at once puts the system into “mute” mode, which can make the system appear not to work. Simply touch volume up again to unmute.

As you have found, the L speaker is simply driven between the two connectors of the RCA plug.

The original satellite speakers consist of four 8 ohm drivers in parallel, so the amp is expecting a 2 ohm load.

해당 답변은 도움이 되었습니까?

예 아니요
점수 2
댓글 달기

옵션

More can be found here,,,,

https://www.petervis.com/speakers/sounds...

Have fun!

Joep

해당 답변은 도움이 되었습니까?

예 아니요
점수 2

댓글 1개:

If you’re intending to use just the sub with no left/right speakers, the control pin jumping from the diagram will only work if you bridge the -/+ wires of each speaker connection - it must require the speakers be “connected” to operate. I simply connected them to each other to complete the series and provide signal feedback. Once both are connected the volume control pins work perfectly.

의

댓글 달기

귀하의 답변을 추가하세요

Jacob Marzynski 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 23

30일 전: 112

전체 시간: 4,151