I have a dual motor lift-board. I’ve had it for a while now but it’s been a since I’ve ridden it. It was good when I was using it. Now I’m trying to start using the board again and it won’t charge. The light keeps blinking red and I don’t know what to do. How do I fix this problem and if I can’t fix it can y’all fix it?
좋은 질문 입니까?
평판: 1.1k
5
5
1
Battery could have discharged too far. Recommendation is to get the wheels spinning for 10-15 minutes (they even go as far as saying to be pulled behind on bike) at roughly 10MPH. Check your remote to ensure it gets a little bit of a charge then try charging again.
I'm not sure what type of batteries these run but if they are LiPo, if not stored properly it can cause issues.
해당 답변은 도움이 되었습니까?
24 시간 전: 1
7일 전: 9
30일 전: 32
전체 시간: 2,254
댓글 1개
Is there a pattern to the blinking? How long has it been plugged in?
mayer 의