기기를 수리하세요 커뮤니티 상점

2014년 9월 19일에 출시된 이 4.7” 스크린 iPhone은 iPhone 6 Plus의 작은 버전입니다. 모델 번호 A1549, A1586 및 A1589로 식별됩니다.

4994 질문 전체 보기

옵션

Why my iPhone stuck at searching, but work when sim slot is pressed?

Hi all,

I have an Iphone 6G. As you can read from title my iphone is stuck at searching ''for signal. My temporary fix is that i turn off my phone, then lift up the screen and, with my thumb, press the sim slot few times. When i turn on phone everything is normal for a while and then it goes back at searching state again. What can i do to fix it permanently? I’m thinking about replacing the sim card slot'', is it a good idea?

Thank you!

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0
댓글 달기

답변 2개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

The answer is quite simple: near bottom side of the Sim card reader you find a big IC called baseband that with bumps and flexing gets slightly disconnected from the logic board and oxide builds in between. Such IC takes care of all radio related tasks in an iPhone. When you put pressure you temporarily re-establish lost contacts. To fix your problem one should remove the IC, reinforce and/or rebuild oxidized rails and connections and resolder it correctly to the board. It’s a relatively common repair on iPhones 6.

해당 답변은 도움이 되었습니까?

예 아니요
점수 1
댓글 달기

옵션

Best thing is to replace the ic. Reflow will work too in most cases.

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 1개:

This IC can't be replaced. A reflow may work for a limited time in a smaller percentage of cases as most often the issue is caused by a broken trace on the board that can't be fixed with a reflow, needs jumpers to be made.

의

댓글 달기

귀하의 답변을 추가하세요

Kosmo Nauti 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 105