주요 콘텐츠로 건너뛰기

Noise cancelling headphones, line in.

2 질문 전체 보기

My battery does not seem to be making contact inside the headphones

I purchased these about a year ago, so the warranty is out. Already checked for normal things like wires disconnected, and corrosion. I did a thorough cleaning with vinager and still nothing. Then I noticed when I put the battery in, and pushed down hard on the top, the green light came on. This worked a few times, and am wondering why it is doing that. Recently I had them sitting on a table, no drops or falls to cause something to be dislodged…

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 1개

가장 유용한 답변

I had the issue with a pair in which the battery had been left during storage. As often happens with those copper-colored batteries, it leaked. I was able to apply a few drops of white vinegar to the spring and spring holder in the little door to the compartment, then rinse and repeat without getting liquid inside the headphones. I also used an emery board to brighten the part of the spring that contacts the battery. Again, don't get dust inside. Even though you cleaned it, there could be a little bit of corrosion where the spring is held in place or where the electricity flows into the headset, or on the tip of the spring. I put in a new battery and they worked!

해당 답변은 도움이 되었습니까?

점수 1
댓글 달기

귀하의 답변을 추가하세요

image blue 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 7

전체 시간: 252