해결됨: miswiring check wiring then pwr on - Kenwood KDC-BT362U

miswiring check wiring then pwr on

A simple installation in a 1995 jeep wrangler. Kenwood KMR-D562BT. The radio runs perfectly with ignition in "Accessory" position. It also works perfectly in the "ignition ON position. But 2-3 minutes after I start the engine I get MISWIRING CHECK WIRING THEN POWER ON. I have tried "reset" I have checked to no avail to see what is the difference in power in or out between ignition ON and engine running. Nope. I cleaned all the little wires running to the circuit board. Nope Mysterious.

게시일: 2021년 8월 31일

옵션

It could be an interference problem since it only happens with the engine running. Make sure you have all the speaker wires and there terminals insulated.

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 2개:

Thanks Chris. That's what the manual says as well. The wires going to the plug at the radio are firmly engaged in the plug and their insulation is intact down to the plug face. Does this mean i need to start pulling out speaker wiring? What if I disconnected all but one speaker at a time and see if i can isolate which one is the source of the problem? Ian

IAN 의 2021년 9월 1일

@ianmw Yes. That is what I would do.

Chris Stables 의 2021년 9월 1일

댓글 달기

Kenwood KDC-BT362U

miswiring check wiring then pwr on

답변 1개

귀하의 답변을 추가하세요