기기를 수리하세요 커뮤니티 상점

Model A1311 / Late 2009 / 3.06 or 3.33 GHz Core 2 Duo 프로세서

310 질문 전체 보기

옵션

Won’t complete bootup

2009 21.5 iMac. After a very brief power fluctuation (sudden power loss , 3 second outage and the power came back) I attempted to turn my iMac back on. The iMac will chime, the Apple logo will appear and the progress bar will go across the screen until the veery end and then the computer will just stop. I have reset the PRAM and was able to boot into the disk utility and perform a a disk repair. but the iMac still shows the same issue. I am stumped. Any ideas?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0
댓글 달기

답변 3개

필터:
가장 유용함 가장 최근 가장 오래된

옵션

Sounds like a possible RAM problem or a dying HDD. Did the iMac say the HDD was successfully repaired? First point of call should definitely be trying some different RAM.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

옵션

The iMac did say it was successfully repaired. I did remove some of the RAM but the same problems occurred

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

옵션

I removed all of the RAM, added one of the RAM by itself into the iMac and then performed a boot up. No change… the iMac boots up , the startup bong hits and the progress bar starts up and then …nothing. The progress bar just stops. I did this with each of the existing RAM sticks of this iMac. I even tried some extra RAM modules that I had stored away but the same results occur

I’m confused as I am able to get into the disk utility and I’m told that the disk drive is fine. Is it a hardware or software issue ? Would a reinstall of Mac OS X solve this boot issue?

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

귀하의 답변을 추가하세요

Mark Pearson 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 60