기기를 수리하세요 커뮤니티 상점

The Meta Quest 2 (formerly Oculus Quest 2) was released in October 2020 and is the successor to the Oculus Quest.

171 질문 전체 보기

옵션

My X button wont work any more after using too much contact cleaner

This happened a couple weeks back when I noticed my joystick had drift, naturally I grabbed my WD-40 Contact cleaner, took the battery out and sprayed a lot on there, then I used my air duster to dry it called it a day, put the battery back in and loaded up blade and sorcery but I noticed my x button didn't work however the capacitive touch center still worked for it. I replaced the battery and let it dry for a bit but still it wont work.

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 1
댓글 달기

답변 2개

필터:
가장 유용함 가장 최근 가장 오래된

옵션

WD-40 is just mineral oil. The oil probably is lubricating the membrane and switch so much that it cannot read a press. To fix this I would recommend using 90% or higher isopropyl alcohol to clean away the oils. Be sure to not use WD-40 on electronics, as it is meant to lubricate and protect metal parts.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0

댓글 1개:

The original poster said they used WD-40 Contact Cleaner, which is specifically used for electrical components.

의

댓글 달기

옵션

Same. I have used WD-40 specialist contact cleaner for all my oculus controllers whenever I have a drift problem. For some of my games I use the cleaner spray every single day. WORKS WONDERS. I have however had two single controllers break directly after using the spray. One, the joystick just popped right out of a side and was disconnected from the controller! And the other incident was the A button stopped working, for good. Like you I have been unable to repair it.

*The other commenter thinks you are using actual WD-40 and not the one fore electrical parts.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

귀하의 답변을 추가하세요

oisin 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 4

7일 전: 13

30일 전: 75

전체 시간: 773