기기를 수리하세요 커뮤니티 상점

Apple 워치 시리즈 1은 2016년 9월 7일에 발표된 Apple Watch 오리지널의 개선 제품입니다. 대부분의 부품은 시리즈 2 와 동일합니다.

123 질문 전체 보기

옵션

Touch not working after replacing screen (but screen works however)

Hello! I have a 38mm Apple Watch Series 1 where the screen was cracked at the corner and the touch wasn't working. I replaced the screen and it powers on and displays just fine, but the touch still isn't working. I even tried replaced the force touch sensor and it still doesn't work. Can anyone provide any insight please?

The watch is stuck on airplane mode, which I can't change because I can't touch the screen. The side dial and button work and I've tried to force restart it. I've also tried reseating the screen connection a few times and cleaning the contacts with a bit of isopropyl alcohol. Thank you for your help!

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0
댓글 달기

답변 1개

필터:
가장 유용함 가장 최근 가장 오래된

옵션

Did you replace the touch sensor? You often need to when you take the crystal/display unit off.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0

댓글 10개:

Do you mean the force touch sensor (with the gasket)? I did replace that yesterday but the touch still didn't work

의

@playaone - Yes, how did you a fix the display the sensor needs to be compressed to work. Using the wrong adhesive is one thing I’ve seen. The other is the sensor was not connected.

의

@danj the force touch sensor came with a double-sided adhesive gasket - I stuck one side to the body of the watch and made sure it's connected.

During my testing, I did not place the small metal latch that goes on the screen connector (steps 22-24 in this guide: Apple Watch Series 1 Screen Replacement) and did not adhere the screen so that I can test it before closing everything up. Could this have an effect on the touch not working? The display works fine and I can use the side buttons and everything

의

@playaone - the clip is needed. The extra release paper could be causing you issues as it adds an extra layer.

의

@danj I attached the clip but still no change. I may be mistaken, but isn't the touch capability tied to the screen itself? I read on this forum that the touch force sensor isn't really needed for the touch screen to work (I guess touch force is a different function - I'm not too familiar with Apple watches myself). Do you think there is something else I can do? I'm hesitant to fully adhere the touch force sensor to the screen as that would be permanent and if I want to remove the screen again I may damage the sensor.

Thank you for your help thus far

의

댓글 5개 더보기

댓글 달기

귀하의 답변을 추가하세요

alphacat92 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 1

7일 전: 5

30일 전: 19

전체 시간: 195