기기를 수리하세요 커뮤니티 상점

오랫동안 기다려온 인기 MacBook Air의 참신한 업데이트는 Intel Core i5 프로세서, Retina 화면 업데이트, 그리고 기타 수 많은 변경 및 업데이트를 포함합니다. 2018년 11월 7일에 출시되었습니다.

149 질문 전체 보기

옵션

MacBook Air not turn on when opened

Hi, I replaced keyboard on my MacBook Air A1932, I have a problem when I close the lid of the laptop and then open the screen, it does not turn on, but while the keyboard is highlighted. Can you help me out this problem?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0
댓글 4개

You replaced just the keyboard? Or the whole top case?

의

@flannelist Replaced whole top case (661-12594)

의

@Dmt A But the screen works properly otherwise?

의

@flannelist Yes, the laptop is working properly

의

댓글 달기

답변 1개

필터:
가장 유용함 가장 최근 가장 오래된
가장 유용한 답변

옵션

This sounds like issue with sleep wake functions which are integrated with hall effect sensors in the display. These signals also run through the trackpad the device knows to wake up if the keyboard or trackpad is actuated when the display is open. I would make sure a few connectors are seated properly and fully. In order of my suspicion of the issue:

  • The microphone, which is under the "left" speaker and connects to the keyboard's circuit board. It would be easy to accidentally leave in the other top case. One of the hall sensors, which detects the presence or absence of magnets in the display to know whether the display is open or closed is part of this little cable.

Block Image

  • The cable from the audio board that goes over the fan to the logic board. The other hall sensor is included in this speaker which connects to the audio board. It lives under some foam on the sticker side of the speaker.

Block Image

Block Image

  • The connection between the speaker and the audio board.
  • The trackpad cable itself.

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 4개:

The new whole top case keyboard was with the microphone installed.

의

@Dmt A What happens if you reinstall the original top case? Does the issue persist? There could be an issue with something in the replacement top case.

의

@flannelist

Hall sensor appears to be in speaker on audio board side.

Where did you get the information that the sensor is assembled with a microphone?

의

@Dmt A There are two. One is on the speaker, as you mentioned. And one in the top case in the mic assembly.

I edited better pictures into the original post. Ultimately the one from the mic ends up running through the trackpad cable. Which could also be the issue. I would make sure the cable is seated properly. The open signal is sent through the trackpad cable as well, so if it were shorted, or punctured that signal might not get through.

의

댓글 달기

귀하의 답변을 추가하세요

Dmt A 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 5

전체 시간: 144