Will not power on, what could it be?

Question

iPhone 4

4세대 iPhone. 수리는 간단하지만 앞면 유리와 LCD를 하나의 유닛으로 교체해야 합니다. GSM / 8, 16 또는 32GB 용량 / Model A1332 / 검정 또는 흰색.

2375 질문 전체 보기

magistry @magistry

평판: 287

4

1

게시일: 2012년 3월 27일

옵션

Will not power on, what could it be?

TL;DR iPhone 4 will not power on. Logic board is verified working, battery is verified working and charged, dock assembly is verified working.

So here's the deal, I got this dead iPhone 4 for doing some trade work. I have tested the logic board in my own phone, as well as the battery and the dock connector. I cannot, for the life of me, think of anything else it could be. All of these parts work when they are put in my phone but when I put them back into the dead phone, nothing happens. It doesn't charge, it doesn't turn on, and the computer doesn't see it. What the heck could it be?

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요

점수 1

댓글 달기

답변 2개

선택된 답변

SIMRAN @simransingh

평판: 6.3k

24

39

5

게시일: 2012년 3월 28일

옵션

In this phone remove all the jacks . just leave battery and dock connecter jacks with the logic board. then try with usb cable with pc. it will sure power up and iTunes recognize it. then slowly put the jacks back one by one to find out the fault. means first the put the only LCD jack . before this putting back make sure that battery to be unplug. slowly do this . after LCD put the digitizer jack then power button then front camera then back camera then side volumes buttons. then homebuttom. slowly you will find the fault then just change that part only. thnx best of luck...

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 1개:

Thank you so very much! I was able to narrow it down to the proximity sensor/power button cable. I happened to have a spare cable laying around and upon removal of the old one I was able to see some corrosion on the sensors that wasn't obvious from the back side. I put the new cable in and put everything back together and it fired right up. Thanks again for the troubleshooting recommendation.

magistry 의 2012년 3월 28일

댓글 달기

Thank you so very much! I was able to narrow it down to the proximity sensor/power button cable. I happened to have a spare cable laying around and upon removal of the old one I was able to see some corrosion on the sensors that wasn't obvious from the back side. I put the new cable in and put everything back together and it fired right up. Thanks again for the troubleshooting recommendation. — magistry

almurr42 @almurr42 평판: 13 1 · Answer 1 · 2012-04-24T16:37:19-07:00

almurr42 @almurr42

평판: 13

1

게시일: 2012년 4월 24일

옵션

Sir I owe you the life of my iPhone, Thankyou!

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 달기

iPhone 4

Will not power on, what could it be?

답변 2개

귀하의 답변을 추가하세요