I know how to solder and would like to remove the port completely and just have the powerblock permanently attached, I don't know how to tell whats positive, negative, neutral. Any help would be appreciated
좋은 질문 입니까?
평판: 1.5k
10
1
2
You need to use a multimeter, to check voltage and to check resistance (ohms). Even a cheap multimeter from amazon will work.
The center of the plug that goes into the laptop is usually positive. +20 volts dc. The outside ring is then ground, 0 volts.
If you are soldering inside the laptop you have to solder the + wire to where the tip/center metal connects. Use the ohms setting of the multimeter the tip to wire resistence to confirm where the + wire is soldered.
But there is risk of course. If you're not careful inside you could damage the laptop.
해당 답변은 도움이 되었습니까?
24 시간 전: 0
7일 전: 0
30일 전: 2
전체 시간: 9
