주요 콘텐츠로 건너뛰기

소개

Replacing the speaker requires the use of a soldering kit. A guide to soldering is available on iFixit's website here.

  1. Wedge plastic spudger in between the back panel and the speaker of the device.
    • Wedge plastic spudger in between the back panel and the speaker of the device.

  2. Gently pry out the speaker from the back panel using the plastic spudger. Gently pry out the speaker from the back panel using the plastic spudger.
    • Gently pry out the speaker from the back panel using the plastic spudger.

  3. Heat solder and apply to the wires where they attach to the motherboard. This will disconnect the wires from the motherboard.
    • Heat solder and apply to the wires where they attach to the motherboard. This will disconnect the wires from the motherboard.

    • The wires should still be attached to the speaker.

  4. Take the speaker and wires that are attached out of the device and insert a new speaker by soldering the wires to the motherboard.
    • Take the speaker and wires that are attached out of the device and insert a new speaker by soldering the wires to the motherboard.

결론

To reassemble your device, snap back piece back on to device and secure both 2cm screws at the bottom.

Grant Harding

회원 가입일: 2015년 03월 11일

249 평판

안내서 2개 작성하였습니다

Colorado Springs, Team 2-1, Panko Spring 2015 Colorado Springs, Team 2-1, Panko Spring 2015 회원

UCCS-PANKO-S15S2G1

3 회원들

안내서 12개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 2

전체 시간: 83