Beiens Cartoon RC Race Car LED Light Replacement - iFixit 수리 안내서

소개

This guide requires you to use a soldering iron that can be dangerous if you do not know how to use it. I suggest looking at iFixit's Soldering Guide.

필요한 것

1 단계 LED Light

Beiens Cartoon RC Race Car LED Light Replacement, LED Light: 1 단계, 이미지 1/1

Hold the remote control with the backside facing you and, using the Phillips #00 screwdriver, unscrew the six 6.5 mm screws on the back of the controller that hold it together.

2 단계

Beiens Cartoon RC Race Car LED Light Replacement: 2 단계, 이미지 1/1

Open the remote control.

3 단계

Beiens Cartoon RC Race Car LED Light Replacement: 3 단계, 이미지 1/1

Lift the motherboard to separate it from the remote control.

4 단계

Beiens Cartoon RC Race Car LED Light Replacement: 4 단계, 이미지 1/1

To remove the light, use a soldering iron to heat the solder to a liquid and loosen the leads.
While the solder is liquid, lightly pull on the LED to remove it from the motherboard.
The soldering iron will get very hot while it's in use. Be sure to place it on top of a heat protected surface and be careful not to touch the operational end.

결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 2명과 함께

Amber Ashley

회원 가입일: 10/01/15

329 평판

안내서 4개 작성하였습니다

배지 +5개 더

팀

USF Tampa, Team 1-6, Leahy Fall 2015 USF Tampa, Team 1-6, Leahy Fall 2015 회원

USFT-LEAHY-F15S1G6

3 회원들

안내서 8개 작성하였습니다

댓글 0개

조회 통계:

24 시간 전: 1

7일 전: 3

30일 전: 3

전체 시간: 263