소개
For sticky cold/hold buttons, you may only need to clean the button. This guide will show you how to fully remove and replace the button.
Note: This guide requires soldering skills. If you don't know how to solder or want to brush up on your skills check out this handy tutorial.
필요한 것
-
-
-
Hold the hair dryer by the nozzle so that the handle points to the left.
-
Remove the two 1-inch Phillips #2 screws from the back of the fan motor.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
다른 2명이 해당 안내서를 완성하였습니다.
댓글 2개
That's not a capacitor, that's an ion generator like this one https://www.goldmine-elec-products.com/p...