도구

도구는 필요하지 않습니다.

부품

부품은 필요하지 않습니다.

Use a large plastic opening tool along the rear panel: There are 4 clips to release. There are 4 clips to release.
  • Use a large plastic opening tool along the rear panel:

    • There are 4 clips to release.

댓글 쓰기

Slide the cover along the plastic frame. Slide the cover along the plastic frame.
  • Slide the cover along the plastic frame.

댓글 쓰기

Slide off the largest plastic pieces.
  • Slide off the largest plastic pieces.

댓글 쓰기

Bend the second small plastic piece to release it from the rubber piece. Now you can slide it out. Now you can slide it out.
  • Bend the second small plastic piece to release it from the rubber piece.

  • Now you can slide it out.

댓글 쓰기

Slide out the hard drive as shown in the picture Make sure to slide as shown or you may damage the USB bridge logic board.
  • Slide out the hard drive as shown in the picture

  • Make sure to slide as shown or you may damage the USB bridge logic board.

댓글 쓰기

Remove the 4 rubber piece from the plastic frame at each corner. Remove the 4 rubber piece from the plastic frame at each corner.
  • Remove the 4 rubber piece from the plastic frame at each corner.

댓글 쓰기

Remove the rubber piece from the  SATA/USB bridge logic board.
  • Remove the rubber piece from the SATA/USB bridge logic board.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Gaetan

회원 가입일: 2012년 12월 26일

9,249 평판

안내서 30개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 9

전체 시간: 919