주요 콘텐츠로 건너뛰기

DualShock 4 (CUH-ZCT1U) Speaker Replacement

필요한 것

  1. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Check your controller model: 1 단계, 이미지 1/1
    • Check the model number on the back of your controller. This guide was written using model CUH-ZCT1U. If you have another model, the guide procedure and replacement parts may differ slightly.

    • If you have the second generation DualShock 4, model CUH-ZCT2U, use these guides.

  2. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Unfasten the rear case: 2 단계, 이미지 1/2 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Unfasten the rear case: 2 단계, 이미지 2/2
    • If you need to stabilize your controller during this repair, lay it on a soft surface such as a microfiber cloth.

    • Use a Phillips screwdriver to remove the four 6.4 mm-long screws securing the rear case.

  3. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the L1 button: 3 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the L1 button: 3 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the L1 button: 3 단계, 이미지 3/3
    • Use an opening pick to pry each corner of the L1 button from the front case.

    • Cover the button to prevent it from ejecting out of your workspace.

    • Remove the button.

  4. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the R1 button: 4 단계, 이미지 1/1
    • Use your opening pick to pry and remove the R1 button, just as you did for the L1 button.

  5. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Unclip the rear case: 5 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Unclip the rear case: 5 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Unclip the rear case: 5 단계, 이미지 3/3
    • Six plastic clips secure the rear case to the front case. The next four steps demonstrate how to release these clips before you can open the controller.

    • Insert your opening pick at a downward angle between the front case and rear case, halfway between the handle and the action buttons.

    • Slide your pick toward the handle and pry up to release the first clip.

    • Repeat this procedure on the other side of the controller to release the second clip.

  6. DualShock 4 (CUH-ZCT1U) Speaker Replacement: 6 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement: 6 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement: 6 단계, 이미지 3/3
    • Two more clips secure the rear case near the extension port and the headphone jack.

    • Insert your opening pick between the front case and rear case at either side of the ports.

    • Twist your pick to unclip this section of the rear case from the front case.

    • If the rear case feels stuck, insert and twist your pick from different angles.

    • Don't open the controller yet, as it's still held together by two very delicate clips near the triggers.

  7. DualShock 4 (CUH-ZCT1U) Speaker Replacement: 7 단계, 이미지 1/1
    • The final two clips are very delicate, and must be disengaged from inside the controller. If you break them, don't worry—it won't affect this repair or your controllers functionality.

    • Locate the clips by looking through the gap above the R2 or L2 buttons.

  8. DualShock 4 (CUH-ZCT1U) Speaker Replacement: 8 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement: 8 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement: 8 단계, 이미지 3/3
    • Insert the point of a spudger through the gap above the R2 button and push the retaining clip outward.

    • While pushing the clip outward, slowly pull the rear case away from the front case until you feel them separate.

    • Don't fully open the controller until each of the R2 and L2 clips have been disengaged.

    • Repeat this procedure for the clip near the L2 button.

  9. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the rear case: 9 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the rear case: 9 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the rear case: 9 단계, 이미지 3/3
    • Press the R2 button and slide the rear case over it.

  10. DualShock 4 (CUH-ZCT1U) Speaker Replacement: 10 단계, 이미지 1/1
    • Press the L2 button and slide the rear case over it.

  11. DualShock 4 (CUH-ZCT1U) Speaker Replacement: 11 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement: 11 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement: 11 단계, 이미지 3/3
    • Flip the rear case over the top of the controller and lay it down, being careful not to strain the interconnect cable.

  12. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Disconnect the interconnect cable: 12 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Disconnect the interconnect cable: 12 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Disconnect the interconnect cable: 12 단계, 이미지 3/3
    • Use tweezers or your fingers to remove the interconnect cable by pulling its blue pull tab straight out of the socket.

    • During reassembly, reconnect the cable with its blue pull tab facing the outside of the controller.

  13. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Disconnect the battery: 13 단계, 이미지 1/2 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Disconnect the battery: 13 단계, 이미지 2/2
    • Use tweezers or your fingers to grab and disconnect the head of the battery cable from the motherboard.

    • Only pull on the head of the connector—don't pull on the cable itself.

  14. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the battery: 14 단계, 이미지 1/1
    • Remove the battery.

  15. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the reset button extension: 15 단계, 이미지 1/2 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the reset button extension: 15 단계, 이미지 2/2
    • Grab and remove the reset button extension from its recess in the battery bracket.

  16. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the battery bracket: 16 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the battery bracket: 16 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the battery bracket: 16 단계, 이미지 3/3
    • Locate the two clips securing the battery bracket to the motherboard.

    • Insert the point of your spudger into the opening behind the right bracket clip.

    • Depress the clip to disengage it from the motherboard.

    • Lift up the right edge of the battery bracket.

  17. DualShock 4 (CUH-ZCT1U) Speaker Replacement: 17 단계, 이미지 1/2 DualShock 4 (CUH-ZCT1U) Speaker Replacement: 17 단계, 이미지 2/2
    • Insert the point of your spudger in the opening behind the left bracket clip.

    • Depress the clip to disengage it from the motherboard.

    • Remove the battery bracket.

  18. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Disconnect the touch pad: 18 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Disconnect the touch pad: 18 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Disconnect the touch pad: 18 단계, 이미지 3/3
    • Use the point of your spudger to flip up the locking flap securing the touch pad cable ZIF connector.

    • Use tweezers or your fingers to disconnect the cable using its blue pull tab.

  19. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Unfasten the motherboard: 19 단계, 이미지 1/1
    • Use your Phillips screwdriver to remove the 6.4 mm screw securing the motherboard.

  20. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the motherboard: 20 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the motherboard: 20 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the motherboard: 20 단계, 이미지 3/3
    • Be careful not to strain the vibration motor cables. Follow this guide to re-solder the vibration motors if they break off the motherboard.

    • Lift the motherboard from the midframe.

    • Guide the analog stick covers through their cutouts in the front case.

    • Flip the motherboard over the bottom of the controller, leaving the vibration motor cables attached.

  21. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Peel up the sticker: 21 단계, 이미지 1/2 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Peel up the sticker: 21 단계, 이미지 2/2
    • Use tweezers or your finger to peel up the left half of the speaker's sticker.

  22. DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the speaker: 22 단계, 이미지 1/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the speaker: 22 단계, 이미지 2/3 DualShock 4 (CUH-ZCT1U) Speaker Replacement, Remove the speaker: 22 단계, 이미지 3/3
    • Insert your tweezers into the gaps in the corners of the speaker's metal backing.

    • Pry up to loosen the speaker from the front case.

    • The speaker is adhered to the front case.

    • Remove the speaker.

결론

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Clay Eickemeyer

회원 가입일: 09/19/22

63,903 평판

안내서 453개 작성하였습니다

iFixit iFixit 회원

Staff

136 회원들

안내서 16,178개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 31

30일 전: 114

전체 시간: 854