주요 콘텐츠로 건너뛰기

소개

Keyboard removal is necessary to replace heat sink paste and ram.

부품

지정된 부품이 없습니다.

  1. Turn off computer before starting. Flip to the backside of the laptop. Using a Phillips #1 screwdriver, unscrew the 5mm screw and take off the shown cover.
    • Turn off computer before starting.

    • Flip to the backside of the laptop.

    • Using a Phillips #1 screwdriver, unscrew the 5mm screw and take off the shown cover.

    • Using the same screwdriver, unscrew the 8mm screws.

    • The screws may not completely fall out of the laptop, just ensure they are unscrewed as far as they will go.

  2. Flip over the laptop to the top side, and open the laptop.
    • Flip over the laptop to the top side, and open the laptop.

    • Slide the locking tabs down using a blue plastic opening tool or your fingernail.

  3. Using the plastic prying tool, lift the keyboard gently towards you. Don't take the keyboard completely off because it is still attached with a ribbon cable to the computer.
    • Using the plastic prying tool, lift the keyboard gently towards you.

    • Don't take the keyboard completely off because it is still attached with a ribbon cable to the computer.

  4. Pull up on both sides of the black locking tab of the connector.
    • Pull up on both sides of the black locking tab of the connector.

    • The keyboard should now be free of the computer.

결론

To reassemble your device, follow these instructions in reverse order.

다른 4명이 해당 안내서를 완성하였습니다.

Khulan Orgil

회원 가입일: 2015년 04월 14일

1,081 평판

안내서 6개 작성하였습니다

Cal Poly, Team 4-2, Maness Spring 2015 Cal Poly, Team 4-2, Maness Spring 2015 회원

CPSU-MANESS-S15S4G2

4 회원들

안내서 6개 작성하였습니다

댓글 2개

No parts required to *replace* the keyboard?

David - 답글

Did you really need to be told to get a keyboard part to do a keyboard replacement?

Thanks for the guide

Victor Izquierdo Quesada - 답글

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 15

전체 시간: 4,308