주요 콘텐츠로 건너뛰기

소개

This page will guide you through the replacement of the motor block in your Hamilton Beach Classic Stand Mixer 64650. You may also find this guide useful to access many other parts in your mixer that you may be experiencing problems with. Although this guide will require the use of a soldering iron, there is a link provided to walk through the process step-by-step.

부품

지정된 부품이 없습니다.

  1. Flip the handle on its side.  Remove five 3.8 mm Philips #2 screws shown and set aside them aside. Flip the handle on its side.  Remove five 3.8 mm Philips #2 screws shown and set aside them aside. Flip the handle on its side.  Remove five 3.8 mm Philips #2 screws shown and set aside them aside.
    • Flip the handle on its side. Remove five 3.8 mm Philips #2 screws shown and set aside them aside.

  2. Remove the four 8.6 mm Philips #2 screws securing the motor mount and place them aside. Remove the four 8.6 mm Philips #2 screws securing the motor mount and place them aside. Remove the four 8.6 mm Philips #2 screws securing the motor mount and place them aside.
    • Remove the four 8.6 mm Philips #2 screws securing the motor mount and place them aside.

  3. 안드로이드 수리 키트

    A new screen or battery is one kit away.

    지금 장보기

    안드로이드 수리 키트

    A new screen or battery is one kit away.

    지금 장보기
  4. Carefully pull the motor block out of the case. Collect the two spring located on top of the white beater gears. The springs are held in place with compression, and may fall into the case when the motor is moved. Handle the wires with care to ensure you do not break any of them.
    • Carefully pull the motor block out of the case.

    • Collect the two spring located on top of the white beater gears. The springs are held in place with compression, and may fall into the case when the motor is moved.

    • Handle the wires with care to ensure you do not break any of them.

  5. Desolder the six wires connected to the motor using this guide. Make sure to note colors when you disconnect them and remember where to reconnect them later. Make sure to note colors when you disconnect them and remember where to reconnect them later.
    • Desolder the six wires connected to the motor using this guide.

    • Make sure to note colors when you disconnect them and remember where to reconnect them later.

  6. Once disconnected, the motor will slide out easily. Once disconnected, the motor will slide out easily.
    • Once disconnected, the motor will slide out easily.

결론

To reassemble your device, follow these instructions in reverse order.

Gwen Davis

회원 가입일: 2016년 03월 24일

519 평판

안내서 5개 작성하였습니다

UMass Dartmouth, Team 7-3, Catania Spring 2016 UMass Dartmouth, Team 7-3, Catania Spring 2016 회원

UMASSD-CATANIA-S16S7G3

3 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 3

지난 30일: 10

전체 시간: 613