주요 콘텐츠로 건너뛰기

소개

In order for your Hover-1 Coast to be used, you must have a functioning controller. It is essential to have a fully functioning controller for the Hover-1 Coast to be used to it's full potential. This guide is not too difficult and can be done by anyone.

  1. Identify the three screws and using a Phillips #1 screwdriver loosen the the screws. Remove the three screws. Remove the three screws.
    • Identify the three screws and using a Phillips #1 screwdriver loosen the the screws.

    • Remove the three screws.

  2. Pull the backside of the controller off. The inside of the controller should look like this. The marked area is the battery.
    • Pull the backside of the controller off.

    • The inside of the controller should look like this.

    • The marked area is the battery.

  3. Remove the black foam piece covering the battery.
    • Remove the black foam piece covering the battery.

  4. Desolder the battery connections from the motherboard. Desolder the battery connections from the motherboard.
    • Desolder the battery connections from the motherboard.

  5. Using a plastic opening tool, pry the battery off the motherboard. The inside of the controller should look like this.
    • Using a plastic opening tool, pry the battery off the motherboard.

    • The inside of the controller should look like this.

결론

To reassemble your device, follow these instructions in reverse order.

Jace Oppenlander

회원 가입일: 2018년 10월 04일

545 평판

안내서 4개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 4

전체 시간: 99