기기를 수리하세요 커뮤니티 상점

MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement

소개

Faulty Wi-Fi or Bluetooth connection? Replace the AirPort/Bluetooth cable.

필요한 것

  1. MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement, Lower Case: 1 단계, 이미지 1/1

    • Remove the eight 4 mm Phillips screws securing the lower case to the MacBook.

    편집

  2. MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement: 2 단계, 이미지 1/3 MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement: 2 단계, 이미지 2/3 MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement: 2 단계, 이미지 3/3

    • The lower case is constructed of rubber-coated aluminum. Do not excessively bend the aluminum during removal, as any permanent deformation will cause tolerance issues after reassembly.

    • Slightly lift the lower case near the vent opening.

    • Continue running your fingers between the lower and upper cases until the upper case pops off its retaining clips.

    • The location of these three clips is shown in the third picture.

    편집

  4. MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement, Battery: 3 단계, 이미지 1/1

    • For precautionary purposes, we advise that you disconnect the battery connector from the logic board to avoid any electrical discharge. This step is optional and is not required.

    • Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.

    • It may be easier to use your fingernails to lift up on both sides of the connector.

    편집

  5. MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement, AirPort/Bluetooth Cable: 4 단계, 이미지 1/2 MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement, AirPort/Bluetooth Cable: 4 단계, 이미지 2/2

    • Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the logic board.

    • Carefully peel the AirPort/Bluetooth ribbon cable from its channel within the rear speaker assembly.

    편집

  6. MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement: 5 단계, 이미지 1/1

    • Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the right speaker.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 10명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 2명과 함께

Walter Galan

694,644 평판

안내서 1,203개 작성하였습니다

배지: 54

배지 +51개 더

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 9

30일 전: 21

전체 시간: 14,505