Master and Dynamic MW50 Wireless Connector Replacement

소개

If your device is not connecting properly, it might be necessary to replace the Bluetooth wireless connector. This guide will show 7 steps for removing the wireless connector. Soldering is required for this replacement, If you don't know how to solder, click here for a great guide.

필요한 것

1 단계 Master and Dynamic MW50 Disassembly

Master and Dynamic MW50 Wireless Connector Replacement, Master and Dynamic MW50 Disassembly: 1 단계, 이미지 1/3

Master and Dynamic MW50 Wireless Connector Replacement, Master and Dynamic MW50 Disassembly: 1 단계, 이미지 2/3

Master and Dynamic MW50 Wireless Connector Replacement, Master and Dynamic MW50 Disassembly: 1 단계, 이미지 3/3

Pull the cushion off of the desired side by gripping the top of the headphones and pulling the cushion off.

편집

2 단계

Remove the four 5mm screws from the earpiece with a Y1 Triwing screwdriver.

편집

3 단계

Use the Jimmy to lift up the black cover to get inside the device.

편집

4 단계 Wireless Connector

Master and Dynamic MW50 Wireless Connector Replacement, Wireless Connector: 4 단계, 이미지 1/3

Master and Dynamic MW50 Wireless Connector Replacement, Wireless Connector: 4 단계, 이미지 2/3

Master and Dynamic MW50 Wireless Connector Replacement, Wireless Connector: 4 단계, 이미지 3/3

Remove the 2mm screw holding the side cover plate in place with a JIS #00 screwdriver.
Move the side cover off to the side.
The black cable connected to the motherboard from the side cover can be gently pulled off from the motherboard side. It isn't soldered on.