PlayStation Vita 3G Antenna Cable Replacement

이 안내서에는 최근 변경 사항이 더 있습니다. 최신 비검증 버전으로 전환하십시오.

소개

This guide takes you through the process of installing the 3G antenna cable on the PlayStation Vita. This is the black antenna cable on the left of the wireless.

필요한 것

1 단계 Case Separation

PlayStation Vita 3G Antenna Cable Replacement, Case Separation: 1 단계, 이미지 1/2

PlayStation Vita 3G Antenna Cable Replacement, Case Separation: 1 단계, 이미지 2/2

Power off and remove the memory card.
Using a Phillips #00 screwdriver, remove the four 6.4mm screws on the back casing.

번역하기

2 단계

PlayStation Vita 3G Antenna Cable Replacement: 2 단계, 이미지 3/3

Using your fingernail or a spudger, pry open the accessory port cover on the top of the device.
Using a Phillips #00 screwdriver, remove the two 5.4mm screws hidden beneath the accessory port cover.

번역하기

3 단계

Remove the two 5.4mm Phillips #00 screws on the bottom of the device near the charging port.

번역하기

4 단계

PlayStation Vita 3G Antenna Cable Replacement: 4 단계, 이미지 3/3

Beginning at the sides of the device, use a plastic opening tool to separate the front and rear cases.
Continue working your way around the device gently prying it open.
There are still wires holding the front and rear cases together. You may damage the connections if you yank the cases completely apart.

번역하기

5 단계

Gently separate the two cases, minding the battery and the touch screen controller connectors holding the two cases together.

번역하기

One of the shoulder buttons fell out when I was doing this step, along with the piece holding it in place. They go back in just fine when reassembling but make sure that they are oriented properly, of course.

klung - 2021년 4월 3일 답글

6 단계

Using a spudger, free the touch screen controller flex cable by gently prying up the connection.

번역하기

7 단계

Free the battery cable by gently prying up on the connection with a spudger.

번역하기

Any idea what type of pcb header is on the board for the battery? I have a motherboard with a broken header but I cant source a replacement

Jimbo Jones - 2017년 5월 17일 답글

This is where I screwed up so I recommend extra caution for other newbies. Only the black part is supposed to come off. Don't be an idiot like me and pry off too much...

ylimakiminna - 2017년 6월 22일 답글

Yea I messed up there too. Is there a way to fix it?

Alethia Henry - 2017년 8월 7일 답글

This component was far more stubborn than the screen connector when it came to removal. I opted for a smaller tool than the spudger (small flat-head) and managed to disconnect it after determining the best bit size for the job. Screwdriver is metal, obviously, so being gentle helps to avoid damaging anything.

klung - 2021년 4월 3일 답글

broke the white part

Benaya Miller - 2023년 9월 19일 답글

8 단계

Separate the front and rear cases.

번역하기

9 단계 3G Antenna Cable

PlayStation Vita 3G Antenna Cable Replacement, 3G Antenna Cable: 9 단계, 이미지 1/1

Using the pointy end of a spudger, gently pry the 3G antenna cable off of the wireless card.

번역하기

10 단계

Using the pointy end of a spudger, gently pry the 3G antenna cable off the right button board.
Deroute the 3G antenna cable out of the casing and remove it.

번역하기