Protocol TerraCopter EVO Drone Motor Replacement - iFixit 수리 안내서

필요한 것

1 단계 Drone Motor

Protocol TerraCopter EVO Drone Motor Replacement, Drone Motor: 1 단계, 이미지 1/1

Orientate the drone to where the black side of the drone face upwards.
On the bottom side of the drone, remove the twenty-two 5mm Phillips #1 screws holding the black frame to the body.
There is one screw under the rear light. Pry the opaque cover to access the last screw.

2 단계

Protocol TerraCopter EVO Drone Motor Replacement: 2 단계, 이미지 1/1

The plastic frames are subject to cracking.
Wires run through both frames.
Pry the white body away from the black frame.

3 단계

Protocol TerraCopter EVO Drone Motor Replacement: 3 단계, 이미지 1/1

Gently pry the motor from it's socket.

4 단계

Protocol TerraCopter EVO Drone Motor Replacement: 4 단계, 이미지 1/2

Protocol TerraCopter EVO Drone Motor Replacement: 4 단계, 이미지 2/2

Locate these solder points of the leads on the motherboard.
From the front of the drone, the left motor has red and blue leads.
From the front of the drone, the right motor has white and black leads.
Remove the leads from their points on the motherboard with a soldering iron, respective to each motor.
Check out our How to Solder and Desolder Connections guide if you are unfamiliar with soldering practices.

결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 2명과 함께

Derek Vande

회원 가입일: 10/03/19

217 평판

안내서 2개 작성하였습니다

배지 +3개 더

팀

The Citadel Military College of South Carolina, Team S1-G22, Eggleston Fall 2019 The Citadel Military College of South Carolina, Team S1-G22, Eggleston Fall 2019 회원

CMCSC-EGGLESTON-F19S1G22

3 회원들

안내서 3개 작성하였습니다

댓글 0개

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 1

전체 시간: 190