이 버전에는 잘못된 편집 사항이 있을 수 있습니다. 최신 확인된 스냅샷으로 전환하십시오.
필요한 것
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the six silver 11.4 mm Phillips #0 screws that hold the device shell in place.
-
Pry open the device shell using the plastic opening tools if necessary. To do this, locate the groves running along the side of the entire device and wedge it open.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Use your fingers to peel off the foam pad that covers the main circuit board.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the eight black 7.2 mm Phillips #0 screws from the top of the circuit board and lift it out of its place.
-
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the one black 7.2 mm Phillips #0 screw from the plastic piece that holds down the microSD card reader wires.
-
Remove the two black 7.2 mm Phillips #0 screws that hold the microSD card reader in place.
-
You should now be able to lift the microSD card reader out of place.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the two black Phillips #0 screws that hold down the camera & display screen assembly.
-
Pull the camera & display screen assembly up from its slot in the device.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the four black 7.2 mm Phillips #0 screws that hold the screen assembly in place.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Turn the device around to the other side and lift up the screen assembly.
-
Remove the four black 7.2 mm Phillips #00 screws that hold the lens & filter assembly in place.
-
Pull the lens & filter assembly away from the circuit board.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Using the soldering iron, de-solder the various wires from the front and back of the circuit board.
-
There are three pairs of wires on the front side, along with a set of 7 leads for the main circuit board connector.
-
On the back side, there is a set of 9 leads for the microSD card connector.
-
다른 2명이 해당 안내서를 완성하였습니다.
댓글 2개
Boa tarde , na verdade não um comentario, meu spy ney esta com defeito( LCD display)gostaria quem pode me ajudar a me fornecer outro LCD com a placa, nome da loja, site, para exportar pro Brasil.
ribeiro928 - 답글
I’ve just bought one of these for £3, wondered if it’d be too risky to experiment with if I was to circuit bend it? I create visuals & if I added a couple of potentiometers to it, I’d be interested to see if I could get any wild effects from it. It’d be great if I could achieve it with this as I’d hopefully be able to save the videos too in order to put into my animations. Do you think I should avoid it, or has anyone attempted circuit bending one of these? Cheers