TDK Life on Record Trek Max A34 Small Speaker Replacement

소개

This guide is used for replacement of the small speaker on the TDK Life on Record Trek Max A34 if needed. This repair might be needed when the sound quality out of the speaker is poor or if the speaker does not work anymore. This would resolve the problem of no sound or poor sound quality. A special skill of soldering is needed to complete this repair. Other than a knowledge of soldering there is nothing unusual for this repair.

필요한 것

1 단계 Small Speaker

TDK Life on Record Trek Max A34 Small Speaker Replacement, Small Speaker: 1 단계, 이미지 1/2

TDK Life on Record Trek Max A34 Small Speaker Replacement, Small Speaker: 1 단계, 이미지 2/2

Use a TR7 screwdriver to remove the screws from the battery cover located on the underside of the device.
Remove the battery cover.

편집

2 단계

Unplug and remove the battery.
Use a metal spudger to pry off the rubber padding.

편집

3 단계

TDK Life on Record Trek Max A34 Small Speaker Replacement: 3 단계, 이미지 3/3

Use a J00 screwdriver to unscrew the screws that are under the rubber pads.
Remove the battery holder and be sure to thread the wires through the hole within the part.

편집

4 단계

TDK Life on Record Trek Max A34 Small Speaker Replacement: 4 단계, 이미지 3/3

Use a metal spudger to pry off the front and back mesh screens.
You may need to move the metal spudger along the edge of the screen to remove it easier.

편집

5 단계

TDK Life on Record Trek Max A34 Small Speaker Replacement: 5 단계, 이미지 3/3

Use the a metal spudger to pry up the rubber cover on the top surface of the device.
Peel off the rubber cover to reveal the buttons and screws underneath.

편집

6 단계

Use a J00 screwdriver to unscrew the screws that hold the top cover in place.
Remove the top cover.

편집

7 단계

On the backside of the device, unscrew the case screws with a J00 screwdriver.
Only the screws on the backside are needed to hold the frame together, do not remove screws on the front.
Once the screws are removed, separate the two frame pieces.

편집

8 단계

TDK Life on Record Trek Max A34 Small Speaker Replacement: 8 단계, 이미지 3/3

The following steps can be applied to either the left or the right speaker.
Use a J00 screwdriver to unscrew the four screws that secure the speaker.
The speaker should fall out naturally. If the speaker is stuck, use a plastic opening tool or a metal spudger to gently lift it out.
Desolder the black and red speaker wires.
Review the Desolder guide if you are unfamiliar with soldering.