기기를 수리하세요 커뮤니티 상점

Vtech Kidizoom Smart Watch DX Battery Replacement

소개

Battery dead, or not holding a charge? Follow this guide to replace it with a new one! Note: This guide requires soldering.

필요한 것

  1. Vtech Kidizoom Smart Watch DX Battery Replacement, Master Switch: 1 단계, 이미지 1/1

    • Make sure the master switch is "OFF" before disassembly, to avoid an electric shock.

    • Flip the watch over with the back facing up.

    번역하기

  2. Vtech Kidizoom Smart Watch DX Battery Replacement: 2 단계, 이미지 1/1

    • Remove the four 6.0 mm screws on the back plate with the Phillips #00 screwdriver.

    번역하기

  3. Vtech Kidizoom Smart Watch DX Battery Replacement: 3 단계, 이미지 1/1

    • Gently pull the back plate from the watch casing.

    번역하기

  4. Vtech Kidizoom Smart Watch DX Battery Replacement: 4 단계, 이미지 1/2 Vtech Kidizoom Smart Watch DX Battery Replacement: 4 단계, 이미지 2/2

    • Lift the master switch from the circuit board.

    번역하기

  5. Vtech Kidizoom Smart Watch DX Battery Replacement, Circuit Board: 5 단계, 이미지 1/2 Vtech Kidizoom Smart Watch DX Battery Replacement, Circuit Board: 5 단계, 이미지 2/2

    • The speaker wires are fragile. They may break if excessive force is used to remove the circuit board.

    • Removal of the circuit board requires soldering.

    • Gently push on the display from the front, near the camera. The circuit board and display will pop out through the back.

    번역하기

  7. Vtech Kidizoom Smart Watch DX Battery Replacement: 6 단계, 이미지 1/1

    • Lift the circuit board carefully from the casing, without breaking or detaching the speaker wires at the bottom of the circuit board.

    번역하기

  8. Vtech Kidizoom Smart Watch DX Battery Replacement: 7 단계, 이미지 1/1

    • Note which wire is connected to which lead before continuing. There are no markers on the circuit board to indicate where each wire belongs.

    • De-solder the black speaker wire from the circuit board.

    번역하기

  9. Vtech Kidizoom Smart Watch DX Battery Replacement: 8 단계, 이미지 1/1

    • De-solder the red speaker wire, as in the previous step.

    번역하기

  10. Vtech Kidizoom Smart Watch DX Battery Replacement: 9 단계, 이미지 1/1

    • Wait for the solder to cool down and solidify, then remove the circuit board from the casing.

    번역하기

  11. Vtech Kidizoom Smart Watch DX Battery Replacement, Battery: 10 단계, 이미지 1/2 Vtech Kidizoom Smart Watch DX Battery Replacement, Battery: 10 단계, 이미지 2/2

    • Using the plastic opening tool, gently pry the edges of the battery away from from the circuit board.

    • There is a thin layer of adhesive holding the battery to the circuit board. This will remain sticky after prying.

    번역하기

  12. Vtech Kidizoom Smart Watch DX Battery Replacement: 11 단계, 이미지 1/1

    • De-solder the red battery wire from the circuit board.

    번역하기

  13. Vtech Kidizoom Smart Watch DX Battery Replacement: 12 단계, 이미지 1/1

    • Repeat the de-soldering for the black (ground) wire.

    번역하기

  14. Vtech Kidizoom Smart Watch DX Battery Replacement: 13 단계, 이미지 1/1

    • Pull the battery free, and wait for the solder to cool before handling further.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

다른 4명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 2명과 함께

Navin Ramkishun

회원 가입일: 01/20/16

259 평판

안내서 1개 작성함

배지: 9

배지 +6개 더

팀

USF Tampa, Team 10-6, Remmell Spring 2016 USF Tampa, Team 10-6, Remmell Spring 2016 회원

USFT-REMMELL-S16S10G6

4 회원들

안내서 12개 작성하였습니다

댓글 한 개

Where did you bought the battery?

funkysoulbrother - 답글

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 13

30일 전: 43

전체 시간: 8,986