물건을 수리하세요 커뮤니티 상점

#9단계의 변경 사항

편집자 Muhammad Ali Malik-

편집 승인됨 완료자 Muhammad Ali Malik

이전
이후
변경 사항 없음

단계 라인

[* red] Now, it is time to move to the screw located diagonally across from the previous one.
-[* black] Again, tighten the screw the exact same amount as the previous one.
-[* black] Repeat this process until the screws are almost equally tight, that is, when you turn them clockwise, they don't turn.
+[* black] Tighten the screw the exact same amount as the previous one.
+[* black] Keep tightening until both the screws are equally tight: they shouldn't turn anymore.
[* black] Perform the same process for the remaining two screws.
-[* icon_note] Notice that we did not tighten one screw fully before moving on to the next one. This way, we are ensuring that we achieve best equal tightness that we can on every screw.
-[* icon_caution] We want to also make sure that we don't overtighten the screws. You should be able to loosen them without requiring a lot of force. If the screws are too tight, it can lead to fan vibration.
+[* icon_note] The above approach ensures that we achieve best equal tightness that we can on every screw.
+[* icon_caution] You should be able to loosen the screws without requiring a lot of force. If the screws are too tight, it might lead to fan vibration.