PlayStation 4 Pro Power Supply Assembly Guide 단계 #3 기록

#3단계의 변경 사항

편집자 Philippe Morin- 2021년 1월 17일

편집 승인됨 완료자 Carsten Frauenheim

	[* black] Flip the console over so the bottom is facing up.
-	[* red] Use a T8 Torx Security screwdriver to remove the three black 7mm screws in the back panel.
-	[* black] Remove the bottom cover in the same way as the top cover. Grip the cover on both sides and pull up until it clicks. Then slide the cover off.
+	[* red] Use a T8 Torx Security screwdriver to remove the three black 7mm screws in the back panel. (7000-series models only); or *one* 7mm screw (the middle one) with ''7100-series'' models *and* the warranty sticker to the left.
+	[* black] Remove the bottom cover in the same way as the top cover. Grip the cover on both sides and pull up until it clicks. Then slide the cover off; *''With 7100-series models,''* pay attention to the two clips that replace the corresponding screws.