소개

Replacing this keyboard is easy and takes only a few minutes.

  1. Use a coin to rotate the battery locking screw 90 degrees clockwise.
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    • Lift the battery out of the computer.

    댓글 쓰기

  2. Pull the keyboard release tabs (shown in yellow) toward you and lift up on the keyboard until it pops free.
    • Pull the keyboard release tabs (shown in yellow) toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw (shown in orange) 180 degrees in either direction and try again.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

    댓글 쓰기

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Loosen the four silver Phillips screws that secure the RAM shield.

    • These screws will not come out all the way. The screws are held captive to the RAM shield to prevent them from getting lost.

    댓글 쓰기

    • Remove the RAM shield from the computer.

    • The four captive screws will come out with the RAM shield.

    댓글 쓰기

    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • When reassembling your iBook, make sure that you reconnect the keyboard cable before replacing the RAM shield.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 8명이 해당 안내서를 완성하였습니다.

첨부 문서

Walter Galan

571,711 평판

안내서 1,203개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 6

지난 30일: 24

전체 시간: 11,152