iPhone 7 Plus Display Assembly Replacement

1 단계 Display Assembly




• Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.
• Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.
• To re-attach press connectors, press down on one end until it clicks into place, then repeat on the other end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.
• If you have a blank screen, white lines on the display, or partial or complete lack of touch response after reassembling your phone, try disconnecting and carefully reconnecting both of these cables and make sure they are fully seated.
번역하기
댓글 8개
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
2 단계




• Remove the three tri-point Y000 screws securing the bracket over the front panel sensor assembly connector:
• One 1.3 mm screw
• Two 1.0 mm screws
• Remove the bracket.
번역하기
댓글 11개
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
3 단계
• Disconnect the front panel sensor assembly connector from its socket on the logic board.
• This press connector should also be reconnected one end at a time to minimize the risk of bending.
번역하기
댓글 4개
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
4 단계
• Remove the display assembly.
• During reassembly, pause here if you wish to replace the adhesive around the edges of the display.
번역하기
댓글 7개
댓글 달기
댓글 쓰기
1024
취소 댓글 달기

작성자

다른 기여자 2명과 함께

Paige Reisman

회원 가입일: 04/07/14

23,586 평판

안내서 15개 작성하였습니다

배지: 38

• 
• 
• 

배지 +35개 더

해당 안내서 넣기

해당 안내서를 사이트/포럼에 작은 위젯으로 포함하려면 크기를 선택하고 아래 코드를 복사하십시오.

미리보기