물건을 수리하세요 커뮤니티 상점

MacBook Pro (13 Zoll, Ende 2016, Touch Bar) Logic Board Einheit tauschen

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

안내서로 돌아가기
영어
독일어
이전 단계

43 단계 번역중

43 단계
MacBook Pro 13" Touch Bar Late 2016 Logic Board Assembly Replacement, Logic board installation: 0 단계, 이미지 3개 중 1개 MacBook Pro 13" Touch Bar Late 2016 Logic Board Assembly Replacement, Logic board installation: 0 단계, 이미지 3개 중 2개 MacBook Pro 13" Touch Bar Late 2016 Logic Board Assembly Replacement, Logic board installation: 0 단계, 이미지 3개 중 3개
Logic board installation

  • When reinstalling the logic board assembly:

  • Check the alignment of the rubber vibration dampers, and adjust them as needed.

  • Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.

  • Verify that no cables get trapped under the board as you install it. Check each marked location carefully.

Einbau des Logic Boards

Achte beim Einbau des Logic Boards auf folgende Dinge:

Überprüfe die Ausrichtung der Vibrationsdämpfer aus Gummi und korrigiere sie, falls nötig.

Führe das Antennenkabelbündel durch die Lücke zwischen Logic Board und Kühlkörper und achte darauf, dass es korrekt ausgerichtet ist, wenn du das Logic Board absenkst.

Achte darauf, dass beim Einbau keine Kabel unter dem Board eingeschlossen werden. Überprüfe alle markierten Stellen ganz genau.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.