주요 콘텐츠로 건너뛰기

2016年末带 Touch Bar 的13寸MacBook Pro 主板更换

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

43 단계 번역중

43 단계
MacBook Pro 13" Touch Bar Late 2016 Logic Board Assembly Replacement, Logic board installation: 0 단계, 이미지 3개 중 1개 MacBook Pro 13" Touch Bar Late 2016 Logic Board Assembly Replacement, Logic board installation: 0 단계, 이미지 3개 중 2개 MacBook Pro 13" Touch Bar Late 2016 Logic Board Assembly Replacement, Logic board installation: 0 단계, 이미지 3개 중 3개
Logic board installation
  • When reinstalling the logic board assembly:

  • Check the alignment of the rubber vibration dampers, and adjust them as needed.

  • Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.

  • Verify that no cables get trapped under the board as you install it. Check each marked location carefully.

重新安装主板部件时:

检查橡胶减震器的对准情况,并根据需要进行调整。

将天线电缆束穿过主板和散热器之间的间隙,并在将板降低到位时确保其正确对齐。

在安装时,请确保没有电缆被卡在板下。仔细检查每个标记的位置。

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.