알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 2 안내서에 영향을 미칩니다.
22 단계 번역중
22 단계
Battery installation
-
Be mindful of the battery data cable and make sure it doesn't get pinched or trapped under the battery board.
-
If your battery came with adhesive pre-installed on the bottom, flip it over and carefully peel away the liner to expose the adhesive. If your battery did not come with adhesive, apply a thin double-sided adhesive tape such as Tesa 61395 to keep your battery in place.
-
Carefully position the battery and set it into place.
-
Press and hold each cell firmly for 5-10 seconds to secure it to the lower case.
| [title] Battery installation | |
| [* icon_reminder] Double-check the fit and alignment of your new battery before sticking it down. | |
| [* black] Be mindful of the battery data cable and make sure it doesn't get pinched or trapped under the battery board. | |
| [* black] If your battery came with adhesive pre-installed on the bottom, flip it over and carefully peel away the liner to expose the adhesive. If your battery did not come with adhesive, apply a thin double-sided adhesive tape such as [product|IF317-072-4|Tesa 61395|new_window=true] to keep your battery in place. | |
| [* black] Carefully position the battery and set it into place. | |
| + | [* icon_note] Place the battery close to the logic board so the trackpad cable can reach its connector. |
| [* black] Press and hold each cell firmly for 5-10 seconds to secure it to the lower case. |
귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.