주요 콘텐츠로 건너뛰기

iPhone 12 Pro 디스플레이 어셈블리 교체

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 8개에 영향을 미칩니다.

4 단계
iPhone 12 Pro Display Assembly Replacement: 0 단계, 이미지 3개 중 1개 iPhone 12 Pro Display Assembly Replacement: 0 단계, 이미지 3개 중 2개 iPhone 12 Pro Display Assembly Replacement: 0 단계, 이미지 3개 중 3개
  • Support your iPhone on something sturdy such as a hardcover book so it rests hands-free and parallel to the ground; this makes it easier to work with in the following steps.

  • Use a hair dryer to heat along the bottom edge of the iPhone. The screen should feel slightly too hot to touch.

  • For complete instructions on how to use a hair dryer, check out this guide.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick under the plastic screen bezel when the Anti-Clamp creates a large enough gap.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle a quarter turn.

  • Don't crank more than a quarter turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next three steps.

iPhone을 하드커버 책과 같은 단단한 물체 위에 받쳐서 핸즈프리 상태로 바닥과 평행이 되도록 하면 다음 단계에서 작업하기가 더 쉬워집니다.

헤어 드라이어를 사용하여 iPhone의 하단 가장자리를 따라 가열하세요. 스크린이 만지기에는 약간 뜨겁게 느껴질 정도여야 합니다.

헤어 드라이어 사용법에 대한 전체 지침은 이 안내서를 참조하세요.

접착제가 풀리고 틈이 생길 때까지 1분 정도 기다리세요.

안티-클램프가 충분히 큰 틈을 만들면 플라스틱 스크린 베젤 밑에 여는 픽을 끼우세요.

안티-클램프가 충분한 틈을 만들지 못하면 해당 부위에 열을 더 가하고 핸들을 1/4바퀴 돌리세요.

한 번에 1/4바퀴 이상 돌리지 말고 돌리기 전에 1분 정도 기다리세요. 안티-클램프와 시간이 일을 하도록 내버려 두세요.

다음 세 단계는 건너뛰세요.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.