7 단계 번역중
7 단계
Remove top PCB and plastic enclosure
-
Heat up this PCB with either iOpener or a heat gun on low temp (100-120 Celsius) to loosen the adhesive and pry it off from the side.
-
Remove the screws.
-
The last screw is under a tamper-proof sticker
-
Use plastic spudger or tweezers to disconnect the camera flex cable from the top
-
Disconnect the flex cable
-
Disconnect the antenna
귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.