주요 콘텐츠로 건너뛰기

MacBook Unibody Model A1342 Akku tauschen

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

5 단계 번역중

5 단계
MacBook Unibody Model A1342 Battery Replacement: 0 단계, 이미지 1개 중 1개
  • Use the battery's plastic pull tab to lift and remove the battery from the upper case.

  • If you're installing a new battery, you should calibrate it after installation:

  • Charge it to 100%, and then keep charging it for at least 2 more hours. Next, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.

Hebe den Akku an der Plastiklasche an und nimm ihn aus dem oberen Gehäuse.

Wenn du einen neuen Akku einbaust, solltest du ihn nach dem Einbau kalibrieren :

Lade ihn auf 100% und lasse ihn mindestens zwei weitere Stunden am Ladegerät. Ziehe den Stecker und benutze dein MacBook normal, um den Akku zu entladen. Wenn die Ladeanzeige am Minimum ist, dann speichere ab und lasse den Laptop an, bis er von selbst ausgeht. Warte wenigstens 5 Stunden und lade dann ohne Unterbrechung auf 100% auf.

Wenn dir nach dem Einbau deines neuen Akkus etwas Ungewöhnliches auffällt oder Probleme auftreten, kann es sein, dass du den SMC deines MacBooks zurücksetzen musst.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.