주요 콘텐츠로 건너뛰기

MacBook Air 11インチMid 2013 バッテリーの交換

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 12개에 영향을 미칩니다.

2 단계 번역중

2 단계
MacBook Air 11" Mid 2013 Battery Replacement: 0 단계, 이미지 1개 중 1개
  • When handling the battery, avoid squeezing or touching the six exposed lithium polymer cells.

  • Lift the battery from its edge nearest the logic board and remove it from the upper case.

  • If you're installing a new battery, you should calibrate it after installation:

  • Charge it to 100%, and then keep charging it for at least 2 more hours. Next, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.

バッテリーを取り扱う時は、露出した6個のリチウムポリマーセルを押さえたり、触らないようにご注意ください。

ロジックボード付近の端からバッテリーを持ち上げて、上部ケースからバッテリーを取り出します。

この修理ガイドを完成したら、新しく装着したバッテリーのカリブレーションを行なってください。

100%になるまで充電します。充電後も最低2時間はプラグを繋げたままにします。それからプラグを外して、通常通り使用しながら、自然に放電させます。バッテリー残量小のサインが表示されたら、これまでの作業を保存して、スリープ状態になるまで放置してください。スリープ状態に入ったら、少なくとも5時間置きます。それから一気に100%まで充電します。

新しいバッテリーを装着後、通常通り作動しない場合は、MacBook ProのSMCをリセットしなければならない可能性があります。

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.