주요 콘텐츠로 건너뛰기

Reemplazo de la placa del botón de encendido del Kobo Libra Colour

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

영어
스페인어
9 단계
Kobo Libra Colour Power Button Board Replacement, Disconnect the interconnect cable: 0 단계, 이미지 3개 중 1개 Kobo Libra Colour Power Button Board Replacement, Disconnect the interconnect cable: 0 단계, 이미지 3개 중 2개 Kobo Libra Colour Power Button Board Replacement, Disconnect the interconnect cable: 0 단계, 이미지 3개 중 3개
Disconnect the interconnect cable
  • Use the tip of a spudger to lift up the locking tab on the ZIF connector.

  • Use tweezers, or your fingers, to grip the blue pull tab on the interconnect cable and disconnect it.

  • During reassembly:

  • Inspect the ends of the cable and the ZIF connectors for any remaining coating that could prevent a good connection.

  • Peel off the coating, heating the cable and the ZIF connector when the coating becomes too brittle.

  • It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in the connector.

Usa la punta de un spudger para levantar la pestaña de bloqueo del conector ZIF.

Utiliza unas pinzas, o tus dedos, para agarrar la pestaña azul del cable interconector y desconectarlo.

Durante el reensamblaje:

Inspecciona los extremos del cable y los conectores ZIF en busca de restos de revestimiento que pudieran impedir una buena conexión.

Despega el revestimiento, calentando el cable y el conector ZIF cuando el revestimiento se vuelva demasiado quebradizo.

¡No tiene por qué quedar bonito! Sólo tienes que quitar el recubrimiento suficiente para que el cable se asiente correctamente en el conector

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.