주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 17개에 영향을 미칩니다.

12 단계 번역 중

12 단계
Remove the following  Phillips #000 screws securing the front panel assembly cable bracket to the logic board:
  • Remove the following Phillips #000 screws securing the front panel assembly cable bracket to the logic board:

  • Two 1.3 mm screws

  • One 1.7 mm screw

  • One 3.25 mm screw

  • It is especially important to keep track of your screws in this step for reassembly. Accidentally using the 3.25 mm screw or the 1.7 mm screw in the bottom right hole will result in significant damage to the logic board causing the phone to no longer boot properly.

  • Be careful not to over-tighten the screws. If they don't fit easily when you are securing them, they may be the wrong size—don't force them.

ロジックボードに留められたフロントパネルアセンブリケーブルブラケットから、次の#000 プラスネジを外します。

1.3 mmネジー2本

1.7 mmネジー1本

3.25 mm ネジー1本

再組み立ての際には上記手順にあるネジの位置を十分に確認してください。謝って右側下のネジ穴に3.25 mmのネジや1.7 mm ネジのどちらかを装着すると、デバイスが正しく機能せず、ロジックボードに致命的なダメージを与えてしまうことがあります。

ネジを固く締めすぎないようにご注意ください。簡単にネジが留まらない場合は、誤ったサイズのネジを装着している可能性があります。無理に留めないでください。

[* black] Remove the following Phillips #000 screws securing the front panel assembly cable bracket to the logic board:
[* red] Two 1.3 mm screws
[* orange] One 1.7 mm screw
[* yellow] One 3.25 mm screw
[* icon_caution] It is especially important to keep track of your screws in this step for reassembly. Accidentally using the 3.25 mm screw or the 1.7 mm screw in the bottom right hole will result in significant damage to the logic board causing the phone to no longer boot properly.
[* icon_caution] Be careful not to over-tighten the screws. If they don't fit easily when you are securing them, they may be the wrong size, don'tsize—don't force them.
[* icon_caution] Be careful not to over-tighten the screws. If they don't fit easily when you are securing them, they may be the wrong size, don'tsize—don't force them.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.