주요 콘텐츠로 건너뛰기

Remplacement du panneau arrière de la Nintendo 2DS

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 5개에 영향을 미칩니다.

영어
프랑스어

3 단계 번역중

3 단계
Nintendo 2DS Rear Panel Replacement: 0 단계, 이미지 1개 중 1개
  • Use your fingernail or the flat end of a spudger to flip up the connector securing the ribbon cable to the motherboard

  • Remove the cable from the connector

  • Take the opportunity to remove the Left and Right triggers, they have hinges that may break and springs that may jump away.

Retournez soigneusement le panneau arrière pour repérer la nappe qui y est connectée.

Retirez les deux vis cruciformes qui fixent la nappe au panneau arrière.

Profitez de l'occasion pour retirer les gâchettes gauche et droite, elles ont des charnières qui peuvent se casser et des ressorts qui peuvent sauter.

-[* red] Carefully flip the back panel over to locate the attached ribbon cable.
-[* orange] Remove the two Phillips screws attaching the ribbon cable to the rear panel.
+[* yellow] Use your fingernail or the flat end of a spudger to flip up the connector securing the ribbon cable to the motherboard
+[* black] Remove the cable from the connector
[* icon_note] Take the opportunity to remove the Left and Right triggers, they have hinges that may break and springs that may jump away.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.