물건을 수리하세요 커뮤니티 상점

MacBook Air 13" Late 2010 电池更换

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 4개에 영향을 미칩니다.

안내서로 돌아가기
영어
중국어
이전 단계

3 단계 번역중

3 단계
MacBook Air 13" Late 2010 Battery Replacement: 0 단계, 이미지 1개 중 1개

  • When handling the battery, avoid squeezing or touching the four exposed lithium polymer cells.

  • Lift the battery from its edge nearest the logic board and remove it from the upper case.

  • If you're installing a new battery, you should calibrate it after installation:

  • Charge it to 100%, and then keep charging it for at least 2 more hours. Then, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.

  • The replacement battery may arrive with plastic liners and films. The plastic film is easily removable and should be removed before installation. The liner is thicker and acts as a layer of defense against punctures. Do not remove the liner from the battery.

处理电池时，请避免挤压或接触四个暴露的锂聚合物电池。

从最靠近主板的边缘处提起电池，并将其从上壳中取出。

在你使用的电池之前先 校准 它：

充电至100％，然后继续充电至少2小时。然后，拔下并正常使用以排空电池。当您看到低电量警告时，请保存你的工作，并保持笔记本电脑一直打开，直到它因电池电量不足而进入睡眠状态。等待至少5个小时，然后不间断地将笔记本电脑充电至100％。

在你安装好你的新电池之后，如果你注意到任何不寻常的举动或是问题，你可能需要重置你MacBook Pro的SMC。

替换电池可能带有塑料衬垫和薄膜。塑料薄膜很容易撕下，应在安装前撕下。衬垫较厚，起到防止穿刺的作用。请勿将衬垫从电池上取下。

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.